Recent content by buzter

This item has been sold

I have for sale is a Kubota Mid-Mount mower deck (RC60-24B) All spindles have been taken apart and have all new bearings and seals (have reciepts), all casters and belt tensioner were taken off, taken apart, all re-conditioned, and greased, all grease is synthitic on all bearings and casters...

Del, No worries...glad to help..and yes when I replace the valve I will take some pictures.. Buz

Del, That is correct, plug into one and out the other to the solenoid, like 78Vette's pic shows...the only dumb question is the one that is not asked...Let me know how you come out now.. BUZ

My wire that has the spade terminal on it that is connected to the solinoid goes back to the key...like I stated previously it does go thru a bunch of saftey switches also. Can you send a picture of what you have everyone can look at it? Also does yours look like 78Vette's? BUZ

Del, What 78Vette shows looks good...same setup as mine....with spade terminals and all.. BUZ

Del, Take a look at this link what Kubmech has to say http://www.tractorbynet.com/forums/kubota-owning-operating/40814-b2400-starter-problem-2.html See if this helps BUZ

DEL, One other thing, the purple connector will not slip into the existing factory connection that is still on the tractor...unless backwards...male/female ends?? BUZ

Del, By the picture, it looks as if someone has already put a different end on the white wire which if it were me, I would cut the white wire and the purple one and put a butt connector on. If you ever have to hook it up back the otherway, you could always get rid of that factory snap...

Attached is what my solinoid looks like off the tractor, the spade connector at top is where the wire goes from the key BUZ

The factory connection..is what I am speaking of..is it at the solinoid...or before it? Mine might have that factory snap type connection before the solinoid..but right at the solinoid is a spade connector right onto the solinoid. BUZ

Del, Are you talking before the solinoid? or connecting to the solinoid?

Del, Where are you connecting the new relay part...down by the starter? or under the instrument panel? I just can't imagine you having a factory plastic connection like that at the solinoid? Hmmmm...Well answer away..and we will see what we can do....Keep goin till we get it right.. BUZ

What I would probably do is buy a female spade connector attach a short length of wire to it, plug in your wire from your switch..then go from that new short piece of wire to a connector where you can attach the new short wire and the new wire from the John Deere part. Then you don't have to cut...

Del, On the solinoid, there are two large wires on there, one from the battery, and the other goes to the starter, then there is a smaller wire (apprroximately 16 ga. with spade terminal end, mine is black with white stripe) that plugs into the back of the solinoid, this is the wire that comes...