Recent content by bowtech40

It has been a few days since I have been back on here. Not sure why only the rear tires would change the FEL?? I am going to put it in my garage and try and take some measurements. If I can`t figure anything out maybe I will bring it to the dealer. If I were to find something bent, what are the...

Hello, I purchased a very clean B3030 with a 60" mmm. I then bought seperately the FEL attachment. It is factory Kubota. Mounted all the brackets and hardwear and attached the loader. When I operate the loader all works great, but when I lower it the bucket hits the ground 1 1/4" sooner on the...

Holy hannah!!! I just looked up the Howard Rotavator, and it is one expensive toy!!! The KK sounds appealing.

Can anyone with experience tell me if the reverse direction tillers actually do a better job the the standard direction? I am looking at a King Kutter vs. a Landpride RTR1550. The landpride costs about a grand more, but if it does that much better of a job, maybe it`s worth it?

Yes, I will mow before I do anything. The attachments I currently own are a JD LX4 rotary mower, a 5' box blade with rippers and a King Kutter 5' rake. I would think maybe a tiller would be the best but most expensive choice?

I am wondering if anyone has any experience pulling a disc with a B3030, and would like to share the recommended size to by in a 3 point model? I am interested in doing some food plots for Deer, and need something to break up the soil. Mark

I bought my B3030 used with 350 hrs on it. I currently have 400 hrs and just picked up all the filters and crankcase oil for an oil change. The hydralic oil tank holds 19 quarts, and I did not by that today. I am wondering since I do not know the maintenance history of this tractor if I should...

Ok, Thanks for the replies. I will call everything attachments on Monday and bend there ear. But a 1 bottom seems like the right choice.

I am wondering if a single or 2 bottom plow would be better for my B3030? I live in Mn. in an area with clay type soil. Any thoughts?

Not much action on this thread? Maybe this is just a common occurance? It does really bug me though. I will try loosening everything one more time, and then put a jack under the low side when I tighten them up again.

I installed my loader brackets and loader, not rocket science. But when I lower the loader it touches the ground 3/4" sooner on the right side as you are sitting in the seat. Air pressure in the tires is perfect. Any ideas on what to do to make it right? I have loosened all the mounting bolts...

Tired, Thankyou, this is the info. I was looking for. I will find a good used 48" Woods or the like, and use that to maintain. I have access to a skidsteer with brush mower, or there is a logger around here that has one of those 300hp mulchers. Mark

Triple, after reading your post I am beginning to question this purchase. I am thinking maybe I should hire one of the brush cutting/mulching outfits around here to do the trail work, and then maybe just buy the medium duty Landpride cutter to maintain it afterwords? It says it can handles up to...

I have been looking at 60", as I have not seen anything 48" that is that well built. I understand the HP rating, which was why I questioned it in the first place. Why would 1 60" be rated at say 20hp and another at 40hp when they are both 60"? It has to be based on the weight of the cutter...

I am currently looking to purchase 60" rotary brush cutter. I have a B3030, and it says that 24" behind the link pins that max weight is 1670#. The cutters vary from about 600# all the way up to 1200# for the same size cutter. I realize the gear box is bigger and and the material in heavier, and...