Recent content by Blondie70

  1. Blondie70

    L2501 won't start, acts like safety switch

    Sounds like bad/low battery or battery connections to me. Good Luck.
  2. Blondie70

    idle rpm

    Heck....I'm waiting on somebody to answer the question. How low can one set the idle to on a Kubota ? Is it locked into the factory setting ? Can it be lowered from that ? If not....WHY NOT? thanks
  3. Blondie70

    Oil level inconsistant

    I don't think it can be hurt by overfilling....in fact, think it could be running out the top and still not hurt anything....it's low you don't want !!!!!!!
  4. Blondie70

    Hydraulic leak from top of transmission/rear axle housing

    I had mine overfull and it didn't hurt anything. Here's what I did. .....Put tractor on a slight incline with site glass on the upper side. Get a big clean bucket and funnel and reach down there and unscrew the siteglass.....it's plastic and easy to remove. Catch all the oil. While it's...
  5. Blondie70

    Should I worry about rat/mouse damage?

    Rat poison and keep the hood open all the time when parked inside.
  6. Blondie70

    L2501 misfires almost dies when throttle opened up from idle

    The spring clamps are the best. If it were me, I would keep them in place.....research it ...................
  7. Blondie70

    2501 manual trans. tractor is hard to roll

    Thanks Wolfman. That's what I will do.
  8. Blondie70

    2501 manual trans. tractor is hard to roll

    NO DT....it's a 2 WD ...and of course, no loader....about 600 hours. Thanks
  9. Blondie70

    2501 manual trans. tractor is hard to roll

    Tractor hard to roll on flat cement. Can't shove at all to move a few feet. Acts like brakes are on. Brake linkage is loose, not engaging. Brakes work great. I have been running this tractor for a year or two and all is fine with it. No heat detected around brake area. Nothing warm. I went to...
  10. Blondie70

    L3302DT Gear Grinding

    I had one. Always some grinding when shifting. I think it's normal. Got a couple 2501's now and they do it also. I cuss them all the time, but it does not help !!! ha ha Adjusted clutches up one side and down the other.....nary a difference.. You can just sit there for awhile with the clutch in...
  11. Blondie70

    B21 complete loss of hydraulic function

    Could the jolt of the plywood falling have opened the hyd relief valve...and it hung open ???
  12. Blondie70

    Dropped stick in L3800D Hydraulic Fill

    Take it to the stick removal pro. It's gotta come out !
  13. Blondie70

    Tie rods

    What are you running into ?
  14. Blondie70

    Need Help

    I dunno...never seen anything like it. Someone has tho....wait a bit....good luck
  15. Blondie70

    Help with the injection pump of a Kubota D950

    I heard something about a "rack" that gets hung up on those things....think they can be unstuck but am not sure about it...maybe look up stuck rack, etc on a search engine ???? Good Luck