Recent content by BGDD

Howdy Have a line on a 48" Carraro Rotocar 527. Can't seem to find the weight specs on that unit. Seller says he was running it on a L225 and it did a nice job. I looked at the L225 hitch lifting specs and it appears the B7200 has a higher lift capacity. Seems like a good tiller but I'm...

Thanks for all the help guys, found the gasket and re-used just to see and no leaks but I'll grab a couple new ones to have on hand. Go figure though, now have a small leak from loader quick coupler....lol. well I guess that's what happens pulling something apart that hasn't been touched for...

Thanks Dan I didn't see when i took apart but it probably dropped into the sawdust i had on the floor. Dealer in town may have new crush washer in town thanks for the quick response. I downloaded the WSM but didn't see an exploded view of a pump rebuild and pipe fittings. Cheers

So I Removed the pump and piping, Installed the seal and new O ring kit that I got from the dealer. Re-installed the pump, fired it up and i have a leak on the top side of the outlet. I tired giving it an extra tweak but didn't want to strip anything in the pump housing. Any ideas about...

All good finally got a real wrench on it.

No chance the bottom banjo bolt is LH thread....it's super tight and of course no 25 mm or whatever the size is. Top came easy.

Ok thanks I was hoping I could slide out the pump after removing those banjo bolts connecting the large diameter lhard piping. Cheers

Good day I have A couple questions regarding the seal replacement on my B 7200. I've done a fair bit of wrenching in my past but none on this tractor. So thanks for the help in advance. 1) Does the hard piping have to be removed from the pump body and if so and if so can it be slid out...

Howdy I was searching for a service manual for my B7200HSDV and found kobotamanuals.com which advertised manual downloads for 29.99 US. Seemed pretty legit but after paying, I fot the receipt etc but no download link just links that take you back to the same site to "Buu Now" once you've found...

I called and got the seal, gasket and rings from our local Kubota dealer here in Calgary. They also have the pump available for order but $683.....well worst case scenario, it's cheaper than a new tractor, not that I wouldn't like to use that as an excuse to have a shiny new orange toy in the...

Yes the loader operates fine until it starts running short on oil as it's all in the crankcase....lol.

No problem Dan, do you know if Whitehouse is still peddling those pumps? Can't say I'm familiar with the distributor. Could you provide a link or such to this supplier and I'll see if there's any around.

Thanks Dan, Ya I get what you're saying about the meter. Sorry, but you're saying you have a seal kit or pump for sale? If so, I'll take it and throw it on. I have quite a bit of messing around coming up this summer and arm strong steering is getting old.....nearly as old as me...lol

Yes I can change out the seal, just need to find out where to get parts and maybe a section of a shop manual or something might be handy..... Thanks Much

Howdy, I've scanned through quite a few threads on the hydraulic pumps in the B7200's and given my situation of the tractor making oil and blowing out the breather I believe it's the pump. So I drain crankcase oil to normal level and fill hydraulic within an couple hours of hard loader...