Recent content by armyaviatr

Is anyone using the HYDRAULIC CHUTE DEFLECTOR (BX2821A )? I am looking for a picture of how the electric diverter is mounted to the snow blower. I am running a BX2816 50 inch snow blower and a land pride 3rd function kit and I am finding it difficult to get the hydraulic hoses routed from the...

Good luck, I look forward to watching your progress.

Some where I saw a guy in Germany who took a VW engine (diesel) and tranny and put it in a Kubota RTV 900. Maybe something like that would be a better option.

I also put the male and female flat couplers on so that they would hook up the same each time. Did you use 90 degree couplers on the cylinder? My biggest concern is if I rotate the chute in the up position the hydraulic hoses want to hang up on the grill guard. Also I have a owners manual I...

I recently bought a Kubota BX2816 50" snowblower for my BX2680 tractor. The snow blower had manual chute rotation and manual deflector. This past summer I ordered a grapple for my BX and my Dealer talked me into a land Pride 3rd function controller. His augment was the Land Pride was a true 3rd...

I did order the land pride 3rd function valve after my dealer convinced me it was a true 3rd function valve opposed to the kubota valve which is basically a diverter valve. He said that the kubota valve wont let you curl and grip at the same time. Also the Kubota valve subtracts 18 pounds...

Not sure but I think the 3rd function valve in that video is the land pride version. https://www.landpride.com/products/6481/3rd-function-valves

Thank you!

If any one is needing my old dash panel with switches minus the fuel gauge, oil pressure gauge and ignition switch I will make them a good deal. The old one is not even 4 months old and unless I am using the tractor it sits in a heated garage. Replace the original because it had turned grey.

That is a method I hadn't thought of. I like to use a 3ph quick hitch but when I mow I take it off. Also my BEFCO tiller drags if the ground is uneven where I am tilling. Thinking a hydraulic top link will help with that.

That is a method. I am also thinking about a hydraulic top link. My BEFCO tiller sometimes wont raise up high enough so when I turn it scrapes on the ground, thinking a hydraulic top link will help with that problem.

I decided I didn’t like the top link holder on my BX1800. It seems like it is always falling down, so I looked at some newer models and they have a bracket that fits over the pin and slides down onto a smaller pin to hold the top link up and out of the way. My initial thought was to weld a...

I purchased my new to me BX1800. I believe That this tractor sat in the south west sun for 10 years after the owner destroyed the transmission by stomping on the differential lock when the right rear tire was spinning. The result was the final drive, brakes and Main transmission case were...