Hydraulic Fitting Assistance

ccoon520

Active member

Equipment
L2501 w/ FEL
Apr 15, 2019
360
106
43
IA
Does anyone have a good way to take a male 3/16 inverted flare fitting and size it up to a 1/4" JIC? I cannot seem to find any adapters that are Female inverted flare to male JIC.
 

Lil Foot

Well-known member
Lifetime Member

Equipment
1979 B7100DT Gear, Nissan Hanix N150-2 Excavator
May 19, 2011
7,260
2,204
113
Peoria, AZ
Have you tried here?
 

Thunder chicken

Active member

Equipment
M7060
Dec 29, 2019
294
117
43
Northern ontario
Count your lucky stars there’s not British Pipe Thread in the mix....... can you cut the end off the hose and put another fitting on it to not bother with adapters?
 

ccoon520

Active member

Equipment
L2501 w/ FEL
Apr 15, 2019
360
106
43
IA
Have you tried here?
Thanks for the link I'll check it out.

Count your lucky stars there’s not British Pipe Thread in the mix....... can you cut the end off the hose and put another fitting on it to not bother with adapters?
Unfortunately no. There isn't enough hose length if I cut it.