L2600DT. PTO spins. Fluid levels are good. I lift on the handle and nothing happens. I don't hear the pump like in my L2500DT. How can/do you tell if the pump is out/bad? Any ideas before getting a new pump?
I actually did not try the 3PH before I removed the FEL. But the FEL worked as it should.Did the 3PH stop working right after you moved the FEL to the other tractor? If so, you may have interrupted or bypassed the pressure hydraulics to the 3PH.
Thanks for the response. Correct, I swapped them, moved the FEL , control valve, block and hoses.The in line (large line) is a suction line (not a return line) and it might not flow fluid when you pull it off the pump side, most won't as the sump is lower than the pump.
The fact that you have PS say's the pump is working.
So it's not a pump issue.
If I remember right you swapped the loader from one tractor to another, and you swapped the fluid parts (tap) too didn't you?
The holes that the cover covers are, fluid in and fluid out (Better known as PB [power beyond]), the third is a return port, which is only required when the when the loader tap block was installed.
Check to make sure that the lift lever is actually moving the rod that goes to the valve.
My (L model) TPH stopped working. I have pulled the top off replaced o rings, I have a question. It is inverted on table. In the valve body, how do you adjust the two adjustments in it. Before it stopped working, I had the shudder anywhere but at top of stroke, figuring these are out of adjustment. I read somewhere in the past about threading a hole in it and adjusting until some point, but did not note the instructions for when I did have to pull this cover off. Anyone know of what I type?The valve is in the middle of the two linkages.