Search results

I went out to look at a local 6' flail for sale. Guy said it was in good shape. Aside from some normal expected surface rust and grime it checked out well. Everything turned straight and true. The knives looked a bit rusted as it sat for a while they appeared fine. He also had another of the...

At 44 my eyes finally got to the point where I needed glasses. I just got progressives. When I look straight ahead my sight is within the middle range and everything outside of 2' appears a bit skewed (blurred). I have to tilt down a bit and look up to see normal. Kinda makes walking suck and...

I bought a new PD 10 when I got my new L3200. I finally got around to my fence. I am in mid TN so the dirt has some clay and rock. I installed 200 lf so far with a 32cc one man auger so I was more than excited to knock it out with the PD 10. My first impression in it is gutless. It has more...

Just got a new L3200. Was out working the box blade and moving some tree cuttings playing with the FEL. Parked it in the driveway. Came back about 45 minutes later and noticed a fast drip of diesel coming from the fuel bowl area. It did not look damaged. I decided to unscrew it to check the...

Since the B6000 has the hydro and transfluid one in the same when I check the hydro fluid levels should the FEL be up, down, midway? If its down and the level is at the mark how low will it go with the FEL up and could that hurt anything. I suspect those rams can hold a quart of fluid full.

When replacing the seal do I need to pull the housing to tap it out or can I get it done simply by pulling it from the outside and replacing it.

I have a 12v water pump from a jeep build that I did (or undid). Since the B6000 tractor does not have a mechanical water pump and prone to overheating I was contempalting adding it to the tractor.

My newly acquired B6000 has a front loader. Today the rubber on the seal on one of the loader rams buldged out. Its spewing fluid. Looks like I could just take a flat edge and push it back in but no such luck. I cant find any id numbers on the loader frame to search for parts. How difficult is...