Search results

  1. C

    B2601 FEL Drifting down

    The other day while working on my wood splitter I had it elevated with the FEL. About every five minutes I had to start the tractor and raise the FEL up again. Well that got annoying so I left the tractor running and the FEL continued drifting down at about the same rate. There are no obvious...
  2. C

    MX 5100 leak at hydraulic plug?

    A friend brought their 5100 out to our lake lot and it is dripping pretty constantly from a plug located about dead center of the tractor approximately 16in from the back of the oil pan. This plug has some sort of stem that you can push up and down. When pushed up the drip stops. What are we...
  3. C

    Moving camper with B2601

    A friend called and asked if I could help get his camper in place with the tractor due to close quarters with trees. Camper is 34ft and approx 9K LBS. Probably pushing 800lbs tongue weight. I told him I didn't think so due to the weight. But after watching a few videos on youtube I rethinking my...
  4. C

    B2601 third function install

    Ok I finished my install of my LandPride third function kit 380-149A. Needless to say the instructions suck. I am wanting to confirm that I completely remove the tube going from the power beyond port and the connection below the seat and then run my lines to these points. It looks like the...
  5. C

    B2601 third function install at power beyond

    Ok I am starting my install of my LandPride third function kit 380-149A. Needless to say the instructions suck. I am wanting to confirm that I completely remove the tube going from the power beyond port and the connection below the seat and then run my lines to these points. It looks like the...
  6. C

    B2601 Hyd Pressure only 1700

    I have been somewhat disappointed with the lifting capacity of my B2601. Finally measured the pressure and verified all loader ports maxed out at 1700psi. Should I take it back to dealer or install shims myself. I was hoping to see improvement after the 50hr service last fall and did not see...