Search results

Those engines are relatively easy to remove if you have a hoist. And changing the pan is pretty straight forward. I'd say half a day if labor would do it. New providence? Bring it on over to Hoober and we can fix you up!

Sounds like it maybe an HST issue. Usually when they warm up the problem gets worse. You can remove the suction strainer or cut open the hyd filter to check for debris

Unfortunately it is not just 10 or 15 bucks, prob closer to 100 bucks or more for the two filters. All of the hydraulic oil passes through the hydraulic filter on the suction side of the pump. The oil that eventually passes into the hat is pressurized and pumped through the hst filter to filter...

He's right, probably a fuel filter issue. If that doesn't fix it, it may still be a fuel issue, either a pump(rare) or dirt in the fuel tank that could be clogging the out let. I normally always change both fuel filters even though the one under the floor clogs first. They are both the same part...

Oil coolers are usually piped in after the hydraulic load meaning it is at return pressure not power beyond. Power beyond would be a couple thousand psi. Not exactly sure where the best spot is for return oil. Maybe a steering return line.

The 3200 is slightly wider, longer and more powerful than the 2920. However the 2920 is smoother running. The dashes are slightly different and the ignition key placement is different. You may or may not be able to mount the same attachments so be sure of what you are getting before you pick...

I am assuming you meant bx1850. This tractor has no manual diverter valve so dont worry about that. If you are not familiar with the 3 pt operation, you may need to know the hydraulics on this unit are somewhat slow so rev it up and see if anything improves. If your steering loader and trans...

To operate the thumb on this machine you have to press the middle button on the display panel to activate the service port. Then use the rocker switch on your hand control to move thumb open and closed. If it doesnt work, be sure the light is on next to the activation button. There are a few...

When I have seen this issue on B or L series, the controller was the problem.

Kubota uses Super Udt2 in their tractors from new. The oil is supposed to be better in hot and cold temperature extremes. I know it is better than some other tractor manufacturers' oils as I have seen cold temperature cavitation problems with other brands but not with Kubota. The oil Kubota...

EASY THERE WHITEKITTY! We are all friends here. Guess that blue tractor must be seeping into your head. The RTV500 uses an electronic fuel injection system so if there is a problem it SHOULD flash a code out. If you think it is a fuel issue, drain it out, get rid of it, start with some...

The B3200 had some problems early on with white smoking. They say you have to flow time the injection pump which is not a tough procedure but its a little difficult because the timing marks are made to view when the engine is out of the tractor. If you get it to a dealer they should have no...

No, it should not be connected to anything on this model. It is a wire that supplies power while you are cranking the starter. It is used on some applications to power a fuel solenoid during cranking but not on your model.

Do the remote valve levers move freely and are they in the neutral position? I have seen where the cables lock up and the levers dont return completely causing issues for the hydraulic system.

Sounds like a fuel issue. Change the filter and make sure when you have the sediment bowl off that when you open the valve you have plenty of fuel flowing out. Also when it is running and starts to act up, look at the bowl and see if there is any diesel fuel in it. If you can see it sucking...

Be sure to take an airgun and blow all the debris out of the radiator. I have seen tractors overheat with 20 hours on them because the radiator is clogged and you dont see it until you blow air through and all the grass and seeds come out.

To move the wheel back to the center on the bx2360 all you have to do is turn it against the stop in the direction you want it to go and hold it against until it moves as much as you need it to. An L3200 has a direct link to the steering with power assist so it would always be the same when you...

There is not an oil that meets Super UDT2 specs. UDT is comparable but not the same as a UTF fluid. UDT is ok for a gear trans in most cases but if it has an HST, GST, or any hydraulic clutch pack you will want to use Super UDT2. It is formulated to do better all around in cold weather, and is...

I think of all the B20 series tractors we have sold, anything with a mower has been midmount. Easy on easy off very smooth operating. If you are gonna use the 3 point for any other attachments you may want an L series with position control. A B series is generally either all up or all down...

hold down the 2 buttons on the console right side at the same time with the key on. Hold for a couple seconds, it will beep and it will go out