Recent content by Treadman

Hi SDT, thanks. I am on

Thanks North Idaho Wolfman. Yes, unfortunately the 'mechanic' didn't do a great job. I've had to fix a lot more than this injector.........thanks for your advice. I'll get 3 new injectors. Regards, Treadman

Hi SDT, thanks for response. Yes, I would be interested to buy your 3 B1750 injectors. Can I contact you directly. Thanks, Treadman

Hi there, after a mechanic worked on my B1750 engine I have a diesel leak from the middle injector. Leak is at the arrow in the photo. Compression washers are new and no sign of leak at injector rail. Diesel slowly seeps at connection at the arrow after a few minutes running. All connections are...

Hi there, I am replacing the hydraulic oil in my B1750HST. I have drained the old oil, (3 drain plugs removed), replaced the hydraulic filter and removed and cleaned the two hydraulic oil strainers. My Operators Manual states 13.5 litres hydraulic oil capacity, however this is for B1750HSE and...

Hi All, thanks for your tips. I have finally removed the strainer with a bit of heat applied to the housing, a long handled socket and a few hits with a hammer on the drive head. Both strainers removed and cleaned up in paraffin and blown through with air hose. Hopefully this will sort out the...

Thanks Guys for all your help. The nut is steel into the alloy housing so welding on a bar is possible, but hope to avoid that as I have no welding kit or experience. Will try again with a longer cheater bar. If I apply heat could that help? I'm assuming these are conventional threads, i.e. not...

Hi there, I have a B1750 with hydraulic problems. I am trying to remove and clean the hydraulic oil strainer. It's in a fairly confined space so I have taken off the left rear wheel and mudguard and now have pretty good access to the nut. I have a 26mm socket and open and ring spanner. The nut...

Thanks very much. I'll see if I can jack it up and get some blocks under and get better access to the strainer nut. Have a 26mm socket and ring spanner and will try to free it off. Thanks for your help.

Hi there, my first post so thank you in advance for your help. I have a B1750HST with a 60" mid mounted mowing deck. Don't know the age of the machine but must be pretty old - bought as used tractor several years ago. Everything worked fine first couple of years and then developed loss of power...