Recent content by TM9311

BOO!! it has about 1200 hrs. thought thatd be low. depends on history i suppose. I can try a wet test later when i get a chance.

In continuation of my other thread for removing the glow plugs, I decided to test the compression through the plugs. I used harbor freight cheapo kit and turned the end off in the lathe so it was short enough. front rear two read 300 and 350psi :mad: im reading the min is 350 psi. sooo im not...

The plugs may have been getting a little weak IMO. I never tested but seems like it would take a long while to heat up. Newish to me tractor, i just default new items (fuel/air filters, plugs, etc)

This has probably been covered but I wanted to service my 82 l245dt and change plugs. I was hesitant to remove the manifold and/or the injector line Because bad things usually happen for no reason. I ended up cutting and welding a wrench at an angle and removed it without any other items...

i made a piranha bar and they just laugh at it. they just give and fold over. its like deep rooted grass. maybe a plow is what i need? lol

I finally gave in and got a landscape rake to collect the massive amounts of brush and junk that built of from previous owner who left the land go wild. few pictures show before, middle after 5ft brush hog, and current after raking a little bit. The thing that annoys the most is the tiny...

Well turns out I was making way harder than it needed to be. The H piece went between the tube and not to the frame. duh. I will say i had to undo all hte bolts to get it back in there though even thought i followed directions. ALso, suggest making some of the holes a little bigger, they werent...

What are the thoughts on using existing holes. I sandwiched a plate under the two main bolts that holds mine together at the top.

Sent from my iPhone using Tapatalk

I have a 5 ft brush hog and or kubota 48 finish mower I’d trade towards one Sent from my iPhone using Tapatalk

ran out of room. some more. it did mention it and all is say is install "holder" to frame i dont see how it can work unless i have a unique seat mount I was originally going to make one but figured i'd try since it was still on the main website. I couldn't build it for that much. and it...

I contacted my local dealer in regards to the kubota safety program 3 weeks ago. They knew nothing about it (-_-) and said they would call kubota. well a week went by of promising they would call me "tomorrow" and blaming people at kubota I finally got the feeling they weren't too motivated...

Anyone have one in central Il? thanks

what? I wasn't dragging it. I had the pulley up on the tree to help guide/ convince it. Picture was just showing I got it down no problem.

I understand pulleys and how to calculate the force through the driveline, just didn't feel like doing it if someone knew off hand. It was synthetic winch line and rated for 3400 pounds, seems plenty for what it needed to do. One pulley was in use. It was just the way I had it tied off at the...