Recent content by sevengutters

Tractor has been sold !!!

South central ... york,pa. area

Selling my 1991 B7100 HSTD .. 4 WD .. 48" DuAl Loader .. 60" MMM deck 1079 working hours I just replaced a cracked head with a recon head , new gasket , new pilot bearing and new Throw Out Bearing . It runs good now , no leaks and is a good straight machine . Not banged up like some you see...

OK .. Its been along drawn out deal , but thanks to the OTT forum members I finally got my B7100 back together and seems to run good with no leaks :) . When I got the reman head I did leak down test and it held the denatured with a minimum of weeping after a long period of time on the valves and...

............ :)

Thanks for the input ....

I finally got the recon head and gaskets to put the engine back together . A question the clutch housing was pretty oily . I used brake cleaner to flush it and clean it . Should I buy a new throw out bearing for the HST clutch . The existing one rotates fast and it does have a little play in it...

Thanks for the info .

I just tested a BX2680 yesterday and I did notice the same annoying whine . My question is have the bx series had any hydro pump issues or things of that nature ? I did see that most say the whine eases up after some hours of use and after first service . Also the low range trans . setting seems...

Thanks to everybody for their advice , expertise and knowledge . I have came to a conclusion . New Head New Gasket Seal (o ring ) Put it back together and see how it performs . At least the coolant issue should be resolved . I won't put that many hours on it to be concerned...

Apologize . My Other mower has 900 hrs . The b7100 has just less than 1100 hrs. I didn't even get to use it yet . Got it home in January didn't see any leaks at all. It has a nice 60" belly mower , DuAl 45 front end loader . Oil looked dirty so I changed it . The coolant looked good and clean...

I did read here in the forum that a 950 would interchange . Would I have a lot of other costs involved other than transferring some parts over from the 750 to the 950 ?? Thanks

It has 1100 hours on a working meter . Had some blowby , smoke some probably more than some. Its my first kubota so not sure . No strange noises to talk about.It has a newer radiator dated 2004 . Its really a clean machine without much physical neglect . Engine neglect not known (1991) HstD

Thoughts on pistons and rings etc. since I will be putting a new head on it .

More valve pics ...