Recent content by Sammybd

Filter is clean. Everything is tight and my FIL works fine. Is there anything else I need to check? Thanks for all your help and ideas SammyD Sent from my SM-G955U using Tapatalk

Thank you NIW Sent from my SM-G955U using Tapatalk

Lance, No I have not. I will look at it this evening if I can find it[emoji849][emoji19][emoji854][emoji102] SammyD Sent from my SM-G955U using Tapatalk

When I squeeze the hose i can see its satured with fluid so its seen it's better days.I'll thoroughly inspect the line while replacing that wore out hose . I hate those factory clamps so ill change them while I'm in there. Would you recommend draining all the fluid since I just changed it ...

Ok. I might have Found the culprit. This is extremely damp. And it's leaking. Sent from my SM-G955U using Tapatalk

https://youtu.be/FL-NqSwGtk0 Sent from my SM-G955U using Tapatalk

Hear is a video clip of my FEL . https://youtu.be/ku_3R0I3x04 Sent from my SM-G955U using Tapatalk

its a sputtering sound kind of hard to describe. Sent from my SM-G955U using Tapatalk

Afternoon guys, I Started moving my l2350DT around today and noticed my FEL purging a little . Sounds like it's coming from the pump. I tried lifting the bucket and it's slow and purging while lifting and descending. I checked the hydrolic fluid level in the site glass, it looks like it...

Maybe I need to check out tsc on their deals Sent from my SM-G955U using Tapatalk

Are the Y blades reversible? Sent from my SM-G955U using Tapatalk

Ok so I just fill it up through the valve on top of the gear box Sent from my SM-G955U using Tapatalk

So the guy I bought this mower from said I needed to remember to check the oils in it. Is he referring to the gear box? Sent from my SM-G955U using Tapatalk

Thanks, now I need to figure out which knives to order[emoji16] Sent from my SM-G955U using Tapatalk

Thanks for all your comments...... Well I ended up buying a used flail mower since I really don't know if I that's what I want to use on my tractor. If I really like the end result with the "Y" blades then there you go. I think from what I've gathered from your comments is, the challenge will...