Recent content by OrangeRidge

I think there's a fair number of people associated with this machine who don't know how to adjust aspects of anything they can't see as readily obvious .

Good grief ! It's better to give the engine a crank-over after 10 seconds of heater plug , and crank until it fires . The fuel pump will have the diesel to the injector pump by battery power only . A dry engine is no drama until stupidity strikes ............

A few years on , is this still OK ? . My neighbour and I are looking at going halves on a new L4600HD loader/4 in 1 and R tyres on special .

I've just traded the BX2360 for a F3690 72" that was on end of season sale for USD18k plus tax .

I bet you can , and probably from a Kubota Dealer's parts dept .

If you need more latitude in adjustment ( I'm wondering if height ajust/locking dial may have a problem ) there's an option of removing the locking nut from that bolt in picture from post "5" ( ? ) .

I'm all for using old threads that are about the problem . We all get it then with an email-out . Well done . A broken bit is always a teaser ! Hardly any of this stuff is properly adjusted either , for the buyer . It's annoying .

I really don't like the completely inadequate width between the rear tyres of tractors . Even bigger stuff like Kubota B3030 is a few inches narrower than my Hustler Super Z hyperdrive 66" decker . That thing can't overturn for love nor money , but the tractor is a no-no on the slightest slope...

I went 1.5" and a 2.5" for the 54" MMM ( you can buy them made to measure these days ) and they made a massive difference to stability, cut-quality and roll-over piece of mind too ! Removed the rear castors and ground-off some metal to enable a little deck height latitude . I couldn't raise the...

Uploaded digital photos are one of the great aspects of Forum threads. Glad you're good to go now ! :cool:

BX##60 , should be as yours ; 1200psi and 9.5l/min flow.

I posted the link above for a user appraisal ...............

13 months on , and I'm looking into this ................. I found a guy who bought one and reckons the "cushion-effect" is one and a half inches (36mm) on shaft movement . Now , this is fine for rear-supported stuff like mower/slasher decks , but what about carry-alls and equipment that you...

Paul , Well done on being TBN's member of the month . You deserve the title and the award for the best one-man ( and his wife :) shop ) I've ever seen on a forum . You have just about every piece of equipment I could think you'd ever need , short of an aeroplane component X-ray setup ! Neil.

Every three hours ( 11 litres or so ...... ) I fill it up again. The tank's a weird shape , and I think its 25 litre capacity is theoretical when it come to using all the fuel load .............