Recent content by ibentaken

Does any one know how to aline the front end of a 9540 4 wheel drive the issue is the right front tire is warring on the out side and doing it to fast the left front tire is good.

Thanks I will keep trying

I have a 3300 gst the other day I had some oil coming from a plug with a drain in the middle of it. This plug is just behind the motor. it was not engine oil. there is a round cover that appears to be coming from the front I think it is the front drive shaft? Some oil was coming from it also. I...

does any one know were to buy an after market cabin air filter for the m 9000 kubota wants an arm and leg for such a small part.

No problem. If you got some advice I will sure welcome it.

The heat/ac thermost inside the cab. I need to change the thermostat that has the cap tube hooked to it under the roof in the evaporator. Not the selcetor in the cab but what it is hooked to under the roof. They call it the thermostat in the parts.

I had the same problem with a 3300gst. My dealer wasn't much help either. I ask the parts man for a break down of the componets in the system then I changed the relay and the timer. You have to remove the dash on the 3300 to get to these parts. You will also need to remove the tach cable on the...

I need to change the thermostat control in a m 9000 I removed the top but it looks like I neeto remove the whole evaporator unit to just change the thermostat. Has anyone done this. Any suggestions.

Thanks guys I give it a try.

I am unsure of your model but I have a GST3300 and had the same problem with the glow plug light going off and on. I had to replace the relay under the dash. There are three parts in the electrial circuit for the glow plugs. I replaced all three they are under the dash on my machine. As far as...

Does any one know were you can buy parts for a deal because the dealers are why to high. Maybe an internet sight or a supplier. I would like parts for an M 9000.

Thanks for the info. As for the charge I pulled a vacuum and did check for leaks by watching the gauge set to make sure it did not leak and used a scale to wiegh in the charge. I did was out the condenser but maybe not long enough. Thanks for the answer to the fuel question.

First where is the high/low limit cut out switch. My 9000 will run the ac good for a little while then the compressor stops then after awhile starts again. condenser is clean. I wieghed in the charge so I feel it is right and wonder if the temperture switch could be bad. I don,t have gauges when...

Thanks for the tip. It has been awhile since I have been on thanks again.

How is the best way to access the ac unit above the cab. The fan quit working and I need to replace it.