Recent content by coltbean

It will pull this log with skidding tongs no problem.http://cloud.tapatalk.com/s/5becab95ae02b/VID-20181114-WA0002.mp4 Sent from my SM-G965U using Tapatalk

My 2501 is a workhorse. Sent from my SM-G965U using Tapatalk

So what Stihl did you get? Sent from my SAMSUNG-SM-G935A using Tapatalk

Mine was $169 but another $100 in shipping. Just be sure to get one with a shear bolt. Sent from my SAMSUNG-SM-G935A using Tapatalk

So mine is 20" from where the shank ( the black part) comes out of the red frame to level with the tip. In mine and most tractors you will have 3 positions where your top link pins to the rear of the tractor. I had to put mine in the top one because it would bind going down if in the lowest one...

Ok so you basically want the depth of cut. It's still mounted so give me an hour. Also what position is you top link in? If I recall I had to move mine because it was keeping it from going as deep. Sent from my SAMSUNG-SM-G935A using Tapatalk

It's an L2501 so just a cut not a scut. I can measure when I get home. What exact measurement are you wanting? In the 3 point or the subsoiler? Sent from my SAMSUNG-SM-G935A using Tapatalk

I can let it dig in up to the cross bar and so far it hasn't had any problems. I've done some trench g for water run off and used it to dig up a 6" stump. Just pass around the stump to break the roots and then drive straight over till it hooks the stump and lift your 3 point. Sent from my...

I just bought the one from agri supply for my L2501 and it's not as big as that thing. It actually fits very well. That thing is way too big for your bx, the one from tractor supply will be fine for your tractor. Sent from my SAMSUNG-SM-G935A using Tapatalk

I've got the l2501 with the 1860 and it does fine. I've taken down waist tall grass with some mixed in saplings with no issues. Sent from my SAMSUNG-SM-G900A using Tapatalk