Vteks v1 Front End Loader FEL

[Aharrold]

Hello.
I've got a UK spec Kubota B7100 HST
I recently bought a vteks v1 fel.
The fel was for a Kubota B7001 but was informed it would fit my b7100.
The mounting brackets are all stamped b7001 followed by a code 7875.
On attempting to fit the main bracket to the underside of my tractor I think the brackets are too narrow.
Has anyone else had this problem or have knowledge of fitting the fel?
Hopefully I've attached some pictures, the one with the tape measure shows the approx distance between the 2 bolt holes on either side of my B7100 compared to the bracket.

 

[slowgo]

mine is like around 9inches if need exact measurement i could get later

 

[Aharrold]

mine is like around 9inches if need exact measurement i could get later

That's fine thanks. I wasn't sure if it fitted inside the frame etc. As you can see from tape measure I've estimated mine should be 9 inches too. Going to take it to the fabricators today along with tractor to get cut and fitted.
Cheers