Reference to WSM service manual page S-59;
When reassembling PUSH RODS, the WSM state; " When putting the push rods onto the tappets, check to see if their ends are properly engaged
with the grooves." See attached document.
What does this mean? I just placed the PUSH RODS inside the tapplets and pushed down slightly until the PUSH ROD ROD seated itself.
Respectfully,
Mike
When reassembling PUSH RODS, the WSM state; " When putting the push rods onto the tappets, check to see if their ends are properly engaged
with the grooves." See attached document.
What does this mean? I just placed the PUSH RODS inside the tapplets and pushed down slightly until the PUSH ROD ROD seated itself.
Respectfully,
Mike
