first thanks guys for letting me join . second my spelling is a mess ill try to correct it .
i have l3901 dt a few weeks ago i noticed a slight loss in power while working. it worked ok in low but didn'ti have any pep some times. i loaded Mable took her to a church needing a parking lot made out of shell rock. Mable worked great but then started loosen power. i shut down and checked her fluids ,everything was ok until i tried loaden her. she wasn't going i wincher up with a cable strap (i think i may have damaged my sackrawillieack). i tote her home .) next day i take her down she barely crept off the trailer . the smell was of like a burnt clutch and no go i figured it was the clutch. i tore down according to Kubota s.w.m..
I. putter back together which took hour with that wiring get ready fresh filters fluids . it wont roll over; grounds checked go get battery new cables . still wont spin . so i decided it got come back apart. take it apart clutch is spinning fine .
pull shifter off and fine the outer clutch shaft ,turns but the smaller in wont. and ideas where i should start. thanks for yalls time .
I've tore into like a kid on Christmas morning. it more than my pay grade i see one gear out of sync.
i have l3901 dt a few weeks ago i noticed a slight loss in power while working. it worked ok in low but didn'ti have any pep some times. i loaded Mable took her to a church needing a parking lot made out of shell rock. Mable worked great but then started loosen power. i shut down and checked her fluids ,everything was ok until i tried loaden her. she wasn't going i wincher up with a cable strap (i think i may have damaged my sackrawillieack). i tote her home .) next day i take her down she barely crept off the trailer . the smell was of like a burnt clutch and no go i figured it was the clutch. i tore down according to Kubota s.w.m..
I. putter back together which took hour with that wiring get ready fresh filters fluids . it wont roll over; grounds checked go get battery new cables . still wont spin . so i decided it got come back apart. take it apart clutch is spinning fine .
pull shifter off and fine the outer clutch shaft ,turns but the smaller in wont. and ideas where i should start. thanks for yalls time .
I've tore into like a kid on Christmas morning. it more than my pay grade i see one gear out of sync.
Last edited: