L2501 extra wired plug type under left fender

[connortn]

On my 2023 L2501f there is the extra unused female plug evidently for a rear work light. I can't find it in my manual as to what type receptical it is but looks like it's made for spade type male plug and the spades are at intersecting right angles to each other.... kind of like the letter "T" with two connections. Anyone know what type this is or maybe where to find one? I haven't tried my dealer yet as it will probably be a week or two before I'm out that way.

Tks...

 

[Speed25]

Auxiliary lights, operated by the headlight switch up front. I've got a plug that fits into the stock harness somewhere. I'll try to dig it up and get a part number.

 

[connortn]

Thanks Speed25. I may have found them. I searched for "2-Pin Power T-Male/Female Connector". They look the same on Amazon. Others sell them also. I just didn't know what to call it and came upon a post here that identified it. If you know yours fits the Kubota plug a part number would be nice but don't go out of your way just to find it.

 

[Speed25]

Thanks Speed25. I may have found them. I searched for "2-Pin Power T-Male/Female Connector". They look the same on Amazon. Others sell them also. I just didn't know what to call it and came upon a post here that identified it. If you know yours fits the Kubota plug a part number would be nice but don't go out of your way just to find it.

The part numbers have faded off, but I've got the connector and the crimp terminals new in the bag (from Valley Enterprises is all I know). If you want it, just PM me an address to mail them to and I'll pop them in an envelope.

 

[connortn]

Thanks Speed25. Yes, I would like to get the male plug for the L2501. I clicked on your user name and did not see how to "PM" a member. I did see a "start conversation", maybe that's it? It looked suspiciously like I might be posting on the forum rather than a PM and didn't want to give the AI bots any more information than they already have . If "start conversation" is how I PM you let me know.

Thanks...