Finally built a dolly for my BH75.
I used ideas from other people and made use of some rough cut yellow cedar 2x10 i had.
Bucket platform is 21" wide. Stabilizer arm platform is 30" wide. "Rails" are 60" long.
I left a 12" gap down the middle for the boom to dangle down.
4" casters are rated for 700lb each.
I put the casters directly under the points where the weight of the backhoe sits.
I was going to adjust height after its built so i can back the dolly right into the frame receiver with hooking up hydraulics. But it turned out to work just right at the current height of 7-1/4"
I used ideas from other people and made use of some rough cut yellow cedar 2x10 i had.
Bucket platform is 21" wide. Stabilizer arm platform is 30" wide. "Rails" are 60" long.
I left a 12" gap down the middle for the boom to dangle down.
4" casters are rated for 700lb each.
I put the casters directly under the points where the weight of the backhoe sits.
I was going to adjust height after its built so i can back the dolly right into the frame receiver with hooking up hydraulics. But it turned out to work just right at the current height of 7-1/4"
