Bushings or Pins? Back-hoe play

MPope03

New member

Equipment
B8200D, BF300A, BL4520, Howse Box Blade, Cub Cadet 1650
Jan 1, 2015
17
1
1
Palm Bay, FL
I have an old back-hoe on my old B8200. It's a good back-hoe but it has a lot of play in all the joints. I was hoping someone on the forum could tell me if this most likely worn pins or worn bushings, or both. The pins are really expensive from Kubota, but I'm sure having the bushings replaced would cost even more. Any advice?
 

Tooljunkie

Well-known member
Lifetime Member

Equipment
L1501,home built carry all, mini plow blade.
May 13, 2014
4,150
35
48
62
Lac Du Bonnet, Manitoba,Canada
Pins. Best to pull and measure. You will find they are worn more than the bushings, as they are usually not as hard as bushings.
Another angle, machine shop could ream bushings and make oversize pins. Replaced all pins on a loader, improved dramatically.
 

rentthis

Well-known member
Lifetime Member
May 30, 2012
1,010
25
48
summerville,sc
Replacing pins and bushings can be a DIY repair. It's not the easiest thing to do but it isn't to bad. If you replace just the pins, you will no doubt reduce the wobble but replacing both will eliminate it. If you can find a pin, put it through the bushings and see it you still get slop. If so, replace both. If you have the dealer do it, he will likely suggest doing both.