I recently purchased a used B2673 blade in great condition, and then had my dealer install a LandPride 3rd function setup during a recent service on by B2650. I now know I should have taken the blade - when I went to hook it up I realized that the hydraulic quick connects were a different size (3/8 vs. 1/2).
So off to the TS this morning to pick up some couplers, and got everything hooked up. However when I went to use the third function buttons, the blade would only pivot right and VERY slowly return to center and no further when using the other button. I reversed the hookup and got it to pivot the other way with a slow return. I could also grab the blade and move it by hand.
So obviously something is wrong - I assume on my end. I have downloaded every instruction I can find for the blade and 3rd function. Should I have the A and B ports on the 3rd function hooked up to specific ends of the piston? Once I get this sorted I will definitely move the male and female couplers around for specific hookup. My dealer is an hour away or I would stop by.
Thanks in advance for any advice!
So off to the TS this morning to pick up some couplers, and got everything hooked up. However when I went to use the third function buttons, the blade would only pivot right and VERY slowly return to center and no further when using the other button. I reversed the hookup and got it to pivot the other way with a slow return. I could also grab the blade and move it by hand.
So obviously something is wrong - I assume on my end. I have downloaded every instruction I can find for the blade and 3rd function. Should I have the A and B ports on the 3rd function hooked up to specific ends of the piston? Once I get this sorted I will definitely move the male and female couplers around for specific hookup. My dealer is an hour away or I would stop by.
Thanks in advance for any advice!
Attachments
-
118 KB Views: 405