Search results

i know ! i was a mechanic in the army for 20 years and never experienced anything like this. if you have pressure , you always have pressure. and when you don't have pressure you never have pressure, i doesnt come and go.. i have to put it all back together and set some fence post with auger, i...

yes they both are on the right side but when the fluid came out of the valve i blew air through the hoses and the lines in both directions. i got nothing but air, no debris. i even ran a #6 copper wire (rounded the end on a wire wheel so not to gouge the hose) through it to make sure i it was...

with no lines on the right side of the control block the best i could get was about a 3" high stream. when i took one of the lines off the left side , well that wasn't a good idea i'm not sure how high it went i let go of the lever and tried to get out of the way. left side has REALLY good flow...

i will try that first

im going to try that after i check the control valve for debris

i will check for that , i used the liquid teflon but when i took teh lines off they were installed with tape.

it was my fathers and it did work, i rebuilt the tilt cylinder on the left side but i did not start having issues till i changed the hoses.

i took both lines on the right control off and got a spit --- drip ,drip ,drip basically nothing

i will do that tomorrow and let you know what happens

that is very possible that a line is hooked up wrong i replaced all the hydraulic lines , even though i tagged them all i might have got one mis marked. it is too far of a drive to do one at a time so i did all at once. i am retagging them so this weekend i can flush out all the lines and the...

yes i ran it in both directions towards the back fluid came out at a very slow and towards the front of the tractor no fluid came out it tried to go back in.

the metal line on the cross bar i took off the line going to the rod end of the right tilt cylinder.

model is 1200 on the loader

i have a L245DT with a front loader. the bucket will go up and down but wont tilt front and back. i took the splitter line that feeds both cylinders loose and i have fluid coming out at a trickle.