Search results

  1. C

    90w GL-5 Gear Oil - Where to get it?

    Needed for MMM gear box. Dealer had none... counter girl said i guess we use the 80/90 on the shelf. All auto parts stores in Tallahassee, FL had none...Adv Auto, O'Rielies, Discount Auto, NAPA, etc. and on line although Amazon has a PJ1 Hypoid used for motorcycles with no GL-5 noted but...
  2. C

    I'm dreaming of an Orange Christmas

    More Kubota tools...go figure...a garden hose nozzle and more http://compliancesafety.com/itemlist.kub?Category=Shop+Tools&Group=Kubota
  3. C

    I'm dreaming of an Orange Christmas

    I forgot to look at the cost and it was not a present. Next time I go there I'll check or you could call them tomorrow and they will probably tell you. Tallahassee, FL Costco
  4. C

    I'm dreaming of an Orange Christmas

    Many have talked about adding a tool chest to their tractor. Little did I know that Kubota made one and it's available at Costco, at least the Tallahassee Costco. I'm still looking for where it would go on my BX1860...I guess it must be for the bigger tractors....
  5. C

    is 18600 too much for a Kubota B330su?

    rparkinson's Dreaming of an Orange Christmas. What a great dream.
  6. C

    Advice Sought

    Does your invoice state a year? If so and if 2011, being of the legal community in Florida, if you were in Florida I think you would deserve to get what you bargained for. What you received doesn't conform to the "four corners of the contract." I am not licensed in MO so this is not legal...
  7. C

    Do you store your FEL outside under a tarp??

    Do you have any added weight added to your rig. I would think with a bucket full there may be an issue.
  8. C

    BX2350 won't shut off electrically

    Ouch.. Cannot wait for that to happen.
  9. C

    BX2350 won't shut off electrically

    double check the fuse. sure you're checking the right fuse. 10 amp on my BX1860. I had a pinched wire under the seat shorting out the fuse to the solenoid when I'd hit a bump. The fuse if blown is not needed to start again.
  10. C

    BX1800 MMM height adjusting knob

    You must have the deck all the way up before you can adjust the height and the knob only turns one way. I cannot remember which way and BX is out of reach right now.
  11. C

    Bx1860

    October, 2011: New BX 1860 w/ 54 MMM ... no hydaulics $9,600 plus tax before $500 rebate offered at the time
  12. C

    What did you do to or on your Kubota today?

    Gurn. Oil that chopper well. I have one in a sheath on the rops and playing in the rain one day resulted in a rusty chopper next time i pulled it out...
  13. C

    New bx 2360 ?

    I have an 1860. The MMM will go down to the point where you have it set then the 3PH will start to move. It is a fine line but you'll get used to it. I just barely touch the lever and the MMM goes down before the 3PH goes.
  14. C

    BX1860 hydraulics question

    Assuming the MMM and 3PH are all the way up my 1860 lowers the MMM to the level I have it set at before the 3PH starts to move down and yours should also. Just watch it closely and you'll see. It's a fine line before the 3PH starts to move but you'll figure it out.
  15. C

    Drawbar Trailer Hitch

    http://titanskidsteer.com/tractor_drawbar_trailer_hitch.html See the drawbar here...worth the consideration. Was a tough decision for me with all the option available but this seemed to be the best choice for me at this time.
Top Bottom