Search results

I used adhesive backed rubber sheet to cover mine and it works great, Dont recall where I bought it from but its similar to this. https://rubbersheetwarehouse.com/products/copy-of-neoprene-rubber-rolls-60a-medium-hardness

Rant on. Every time I want to use my grapple I have to think about it hard due to the almost impossible to press on flat face quick connects. Even with turning the ignition on and pressing the control switch to dump the third function pressure its still a bear to get them on. I was so tired...

What is the reason for that.

When I was shopping around for my L, one dealer had one in stock and in the quote there was a line item -500.00 faded paint.

Yup you are correct, googled 9Y110-02420 and did not check the pdf.

https://www.southeasternequipment.net/v/vspfiles/downloadables/PM/AD/SM9Y110-01760%20-%20Kubota%20Diagnosis%20Manual.pdf

I have a husky with the computer carb and it starts and runs perfectly without any issues cold weather hot weather whatever. That is UNLESS you do not follow the exact starting procedure, then it will refuse to do anything kinda like getting some fun from your wife when she is pissed at you.

I would do a compression test first, if it is low then there is no point diagnosing fuel issues.

Where's Waldo. Actually his name is Monty and he is 4 months old and 45lbs in this picture. He pretty much vanishes when he is in the leaves. We have had a few German Shepherd Dogs and this guy has been the easiest to train, non reactive and very calm with new things.

I have a L3302 and I will spin the implement by using a steel bar in the U-joint to line up the splines. The PTO shaft cannot be rotated by hand.

Not trying to be an ass but it appears that you are not really mechanically inclined, the best thing for your situation is for you to get someone who has some mechanical ability and have them examine the machine and provide you with a diagnosis.

Welded professionally for two years, zero reason to invest in expensive equipment for part time welding jobs around the house. Buy a 220V Amazon mig/stick welder and use flux core wire (no gas). Buy a good mask and and get someone that knows how to weld to train you.

Ok so has anyone found the PN for the strainer that fits L series? Now I have to get one because yesterday I went to fuel my L 3302 and was too lazy to get my pump so I unscrewed the cap on the fuel can and I watched a pine needle fly into the can. I have a large funnel with a brass screen and...

I did not have any additional cost, my homeowners property automatically covers it. All I had to do is get a rider on my policy that Kubota is the payee.

In my manual it states. "When applying the grease to the both front-axle supports, apply grease until the grease overflows from the breather port." That is why I asked the question because the manual calls it a breather port ant the parts list calls it a bleeder.

Ok, like a grease relief valve.

What is item 170 Bleeder for? This is for a L3302. No issues just curious.

Its a Yanmar Vio35, image is the bottom of the bucket. I cut out and welded on a new tooth adapter (right side in the pic) and replaced two other teeth but two remain. The crazy thing is both moved, one moved at least 3/8" and the other maybe 1/8". Heat and beat numerous times but no joy. I...

I need to replace all the bucket teeth (5) and one tooth adapter. The teeth are held by a roll pin installed top to bottom. I managed to remove one pin without issue but the rest are frozen. I tried some heat and a 3lb hammer but it did not seem to help. I stopped before I mashed them, so any...

Our 3 month old German Shepherd pup. His coat is a oddball color "isabella". This guy is sharp and is one of the easiest Shepherd puppy's we have ever had.