Search results

I charge $200/hr. With a minimum of 1 hour. And if I have to travel more than 10 miles it’s $5 per mile

Yup mine came with soils tires. I grease it twice a year and change the gear box oil at the beginning of each season. I have 2 sets of blade. I put a sharp set on at the beginning of the season and then change them about have way through with another set I just put a new belt on mine this...

I run a 1660 behind my B2650. And it handles it fine. I can cut grass 8”-12” and it goes through it fine just low and slow with the thick grass

Ok awesome thanks for all the help. That relieves a lot. Though I was going to have to call my dealer on Monday. Thanks for all the help

No I don’t think the wheel is bent. I’ll check it tomorrow and give an up date I didn’t know if I bent a spindle or a bearing was bad. I only have 290 hours on it

Tire pressure is good. It is leaning out at the top. Tire is on the rim fine. Sorry about the bad picture

Look Just like the other side It was straight

I was driving over a 6x6 and turning the steering wheel to avoid a swing set be hide. And this happened

I used my shop vacuum when I changed mind on my 2650 Wife held the hose on the fill port while I changed the filter. And YES it does work. But not enough suction to pull the SUDT up in the vacuum

Not familiar with your machine, but on my B2650 it’s all one. The fill port in in the back I think most FEL run off the tractor hydraulic

I put 50-80 hours a year on my tractor. I do an oil and filter change every year with a fuel filter change at the same time

On my B2650 when I put the backhoe on I’ve got to take the 3PH off

Ok thanks for all the advice. I haven’t made my mind up to get a 72” mower. I run A 60” Now and does fine. Thanks again for all the advice

Ok thanks for the info

Would a B2650 pull a 72” finish mower ok. I’ve got a 60” and was thinking about upgrading to a72”

I have the same problem with my BH77. And have since I’ve had it One pin slides in very easy. But the other I have to use a rubber mallet to put it in and a screwdriver to remove it No adjustment with the stabilizer helps

Another awesome place to buy trailers are is Va Outdoor products. I’ve bought 3 trailers from them and awesome every time. They are in King William Va. Sal is the owner and amazing guy to work with. I sent my neighbor to see him and he beat A national dealer by a a few hundred bucks

I wash / rinse mine every time I use it. And wax it in the spring and fall with a spray on wax

When I did my coolant change I called my dealership and talked to a guy in service. He told me they use Zerex. The green stuff. That’s what I put in there a couple years ago and so far so good temp stays down and seems to be doing fine

Where is the flasher on the B2650. I don’t have a WSM. And I didn’t see anything in the owner’s manual