Search results

Yes, the machine shop needed the piston and rings before anything was bored. Only one shop was involved, and the engine was only machined once.

I have ran it for 2 or 3 15 to 20 minute increments. I did read that you should load the engine as much as possible to seat the rings, so I ran it at full rpm for about 20-30 mins while periodically lifting the bucket up and down and using the hydro attachment until it would bog down then almost...

Has anyone completed a successful rebuild using an aftermarket rebuild kit? I rebuilt my D722 using a Friday Parts kit. Once I was complete the engine took a long time to start up, but it did run. It has a lot of blow by and the cylinder with the most compression only had 310 psi. The service...