Search results

Thanks. I'm looking at SunGuard as well. Their website does want you to at least indicate an over or "up to" size so I want to make sure. Roll Bar Measurements (outside to outside)? Up to 42.5" Width Over 42.5" up to 46.5" Roll Bar Tube Size Up to 2.25" x 4" Over 2.25" x 4" or Round Tube...

I'm looking at buying a rhinohide or sunguardusa canopy. Haven't decided yet. Different materials used, one can be colored, one not but the concept is the same. My tractor is a couple of hours away and I'd like to order a canopy sooner than later. I'm also in Canada and will pick up the...

Thank you. What I might do in the meantime is apply a small amount of gasket sealer from the outside to hopefully prevent anything from getting in there. Denis

Thanks for the reply. I did tighten the bolt and lock nut but not with a torque wrench. I'll try that this weekend. If that doesn't work then I assume the seal is bad and I'll have to replace it or get some gasket "maker" and plug it up for the time being and keeping an eye on it.

Hi. I was doing my 100 hour maintenance. When putting grease into the forward front axle support some grease is leaking out of the bottom. I did manage to get it coming out of the breather plug but there is a lot coming out of the bottom at the same time. Does anyone know if it's simply a...

Sorry, my bad. I meant diff lock not 4 low.

I only have ~38 hours on my L2501 and it's the only tractor that I've owned so I have no idea of the difference between the R14s and others. I use my tractor to clear trails in hilly, rocky and sandy conditions as well as some mud work on 50 acres of land. So far I have nothing but good...

Thank you!

Hi. I installed the stabilizer kit ( Part # L8430) this weekend on my L2501. I meant to remove the lower bolt and nut (the one that attaches to the frame) from one of the side links so I could bring it into town and replace them with a pin / R clip for faster install and removal. Anyone know...

Thank you. I was wondering what that part was called as well. All these new terms with tractor ownership.

Thank you!

Hi. I purchased a skid plate for the hydraulic valve on my new L2501 . The line going to the rear of the tractor dips down below the filter canister. I need to move it up to clear the new skid plate. I've attached a picture to show how the line is at the moment. I've been told that I can...

Thanks. Congrats. I can't wait as well. I just have to make sure I don't change the landscape into a moonscape. ;-) Denis

Thanks.

Thank you. Is that the "Arrow" metal carport? If not it looks like a similar design. I've been looking at them lately. I'm looking at the 10x20. I would normally build it but I'm feeling lazy and the price of wood is through the roof. Do you like yours? Denis

Perfect Thanks. Denis

Thank you both. Denis

Hi. Not really on topic but I wasn't sure which forum was appropriate. I'm waiting on an l2501 with fel and bh77. It's going to be kept at a remote property so I want to build a lean to car port for it before it arrives. I know the max width (the 66 inch bucket) and the max height (with rop...