Search results

Checked at the pto valve spool I finally got the plug out it shows how to adjust it in the wsm there is a regulator valve on the right side of the tractor

Guys I think we got figured out I was able to get the pressure to 370 and my pto winds right up with no hesitation I appreciate the help I am concerned why the pressure was so low? It was 250

It is with independent pto and I cannot remove plug to test the pressure there is there any other way to test if not I’ll have to get couple parts ordered and get back later to you

Ok I looked at the pdf I’ll check the pressure there if I can I know there are steel lines right in front of it

I will check serial number tonight after work and I checked the main hydraulic pressure it was 2275 book shows about 2350 min and 2489 max I shimmed it and now have 2425 psi the pto seems to work now when I try it it’s starts to spin then gradually goes faster and works this takes about 30-45...

Ok I can give this info thank you it is a glide shift transmission it’s l4200 DT tractor without a mid pto I have the wsm. When I engage the pto the shaft will spin most of the time to my backhoe attachment but when you pull a lever on it the shaft will just stop turning sometime I just drive...

Did I do something wrong here? Not one reply from anyone could use some help

Please help My pto works sometimes when I engage it and sometimes won’t do anything I’ve changed the oil and filter also adjusted the cable where I have maximum oil flow through. When it goes there is no problems but some times it spins until I use backhoe lever and it will just stop? Any...