Search results

Thank you. This is very helpful advice.

thanks for the tip on the kubota gray factory. I’ll order that for next attempt. Fairly certain the housing is not cracked. It’s more likely that there’s a non-factory bolt that is causing the leak.

Hello, I have a L4200DT. There's a low pressure hydraulic leak at the bottom of my rear axle case. Right at the bottom of the case. I removed the wheel and successfully removed old worn liquid gasket. It appeared as if someone before me had done the same repair. I replaced the gasket with...

Well, I hate to admit it, but I think I just had a bad fuel filter or fuel filter install. I ordered a new filter, as well as two new O-rings and the spring that goes in the bottom of the cup. Everything seems to be running fine now. Thank you for the help.

Thanks for the help. I’m currently removing the tank to treat it for rust. It’s a mid 90’s tractor so does have a metal tank

Update. After looking closely at the fuel filter, I believe I have a lot of rust in my fuel tank. I guess my question now is, why would the tractor operate fine at low speeds, but stall at high rpms? Now have to decide if I want to spend $500+ on a new tank or try a rust treatment first. Any...

I have a l4200 diesel tractor. I recently bought a 78” woodsmaxx flail mower and have been happy with the performance until recently. I’m engaging the pto at a low rpm then revving up to about 50% or 75% throttle. Everything seems to be working fine for a few minutes, then the engine stalls as...

I'm having the same issue. Nocash....when you say you cracked the feed to the control box, do you mean the controller on the front loader? Or do you mean a different box?