Search results

I recently acquired an L3710 GST, and although I've only used HST in the past, I am getting used to the GST pretty easily. The previous owner used the clutch to switch between forward and reverse, so I faithfully pressed the clutch so far to move the shifter to neutral, then forward or...

I am about to change the motor oil on my (new to me) B7800 and after reading about oil recommendations on the web I bought a gallon of Mobil Delvac Super Heavy Duty 1300 15W40 oil. When I look at the WSM (which I should have done first) it shows 10W30 or 10W40. Is that plain old motor oil...

Hello everyone, I bought a Parker Racor 120AS diesel filter assembly to replace the factory filter so I can check and drain any water easier on the B7800. I will also install a shutoff valve before the filter. The inlet and outlet hose barbs were easy to find (1/4 NPT I believe), but I can't...

Hello everyone, When I try to start a B7800 should the center pin of the stop solenoid extend or retract while I am cranking the engine? I had posted another thread where I was suspecting the clutch safety switch, but since that did not seem to be the problem, I replaced the solenoid last...

I finally used my 2006 B7800 for about 20 hours last week and found that once it warms up, if it stalls or I stop it for any reason, it will crank but not start unless I push the clutch back and forth a few times until something "catches" before the clutch is pressed all the way down. When the...

Hello everyone, I bought a Modern AG Competitor 5 ft shredder with a Kubota B7800HSD (my first real tractor!), and when I revved up the shredder the first time I noticed dark gear oil coming past the seal where the PTO shaft connects to the shredder gearbox. There is a good bit of play in the...