Search results

Da Dave, I fixed the problem thanks to your input, I appreciate your time and effort. Rex

Thank you I’ll check it out first thing in the morning, I didn’t think to check a parts diagram. Brilliant.

I have a B3350 and just added rear remotes and a hydraulic top link cylinder. That all went well and it works great. Since the upgrade my 3 pt migrate down unless I manually hold the control lever or set the control lever stop screw. In the past I used the set screw to avoid dropping the three...

I finished my remotes today, it all went pretty smooth. I used an Upunar expander on the return tube so the tee went in pretty well. No leaks, I’m waiting for the top link to try it out. Does anyone have a suggestion for a lift arm cylinder?

Thanks again, I’m stoked about this upgrade, I’ve read this several times but didn’t quite get the return to tank info...

Yes the t port, I know where it’s located on the loader valve. Did you cut the hose add a tee, then run a hose to the valve body? What size hose and is it a specific type? My prince valve instructions state the return to tank pressure is 500psi. The hose on the tractor looks a little...

Will you show/tell me how you tied into the tank port from the fel? I think I understand the rest....

What my owners manual says, hold the glow plugs on for 3 seconds above 32 degrees, 5 seconds for 23-32 degrees, and 10 seconds for 5-23 degrees. Attempt to start, if it doesn’t start in ten seconds repeat...

My owners manual states to set the throttle at “about half” before starting. It then states the length of time the glow plugs should be warmed according to the outdoor temperature. So does that negate the thought that the obc controls the glow plugs?

I’m not sure the tractor does anything to idol up when it’s cold. I believe that was left to me, it does however increase and decrease engine speed during the parked regen.

Thanks sdt I’ll keep it in mind

Thanks orange...

The swinging bracket on mine is slightly bent forward and has a slight drag. At worst use one of those tiny bungees. I needed a couple washers and didn’t want to wait for them to be shipped. I went to tsc and picked up two washers ID 1” x OD 2 1/4”. I drilled them then bent them over. They...

Mine came in yesterday, thanks for the info. They sound great and drown out the tractor.

Got it, I think I saw that somewhere today, thanks sheepfarmer.

Sheepfarmer, I’m just getting a rotating wheel which is better than before. I’m gonna log off and on. Fingers crossed.

Sheepfarmer, I can’t get the diagram to upload.