Search results

I adjusted it and now have the correct play but the 3pt handle still drops.

Ok thank you. I will mess with it tommorow.

Do I need to take the lift arms off and reposition them?

I adjusted to linkagae to the lift arm a bit. The second part of the test asks you to raise the loft arm all the way up. Then manually lift it. I can't do this. It maxes out the lift with 3/4 of a inch to go still on the lever. When the lever drops it feels like a spring pulling it down.

Perhaps I read the article wrong and this has nothing to do with the 3 point dropping. But yes I have a loader.

Any one know where to get the adapter e to check the pressure?

Thank you very much

No I don't. Where's a good place to buy one.

The lever goes straight into the control valve. There is a linkage off the top arm that also goes into the control valve. It has a jam nut and I don't feel any slop.

Have been having this issue a few years. Have read lots on 3 point drift. When the attachment drops the lever goes down also. I have replaced the Piston seal two times now and honed the cylinder. Adjusting the drop valve dosent let the 3 point drop past halfway to the lockside. 3 point drops...