Search results

Well it's been over a mounth now and my dealer has contacted the rep and he put in for a replacement part but the Kubota warranty system just kicks out the request. Kubota system just says out of warraty. It's funny how difficult it is to talk to a real person. I will try to contact someone at...

Your correct, it's wonky to.

It's hard to know with out a blue print of the hole locations. I think it's just the side plates are welded out of alinment.

Sorry I ment to say the upper end of the boom cylinder.

The first picture is the upper boom cylinder pin in place, the second picture the pin is out and you can see how the cylinder hangs to the left. The two mounting plates at the upper dipper pivot holes are misallined about 1/8". How the guys assembling this thing thought this was ok is beyond me!

Hopefully these pictures will help. :-)

Has anyone else had a dipper arm with the upper pivot plates welded out of alinement? I had rubbed a hole through one of my hydraulic lines and had to pull the upper boom pin out to access the hose when I noticed the lower end of the dripper cylinder didnt slip out of place. When I pulled the...

How many PSI. should I have?

Ok, tried easing into the dirt pile. I have all 4 tires digging now, but the loader still does'nt seem like its lifting to capacity. How do I check to see if my hydualic presuse is correct?

Low and 2500 rpm, and still wont spin the tires at all when digging into a pile of dirt. Motors not bogging down either.

I soupose I am, I know its posible to increase the loader presure. I have seen people do it on youtube, but I dont have a factory service maual yet so Im not sure where to do it on the 2601. As for the hydastatic transmision, is thier a way to put a little more power to the ground?

Re: Loader wnt lift to capacity on B2601 It seems that the geometry of the loader could cause it to lose lifting power as it rises. It just doesnt seem to be as powerful as the loader on my old B 2620. Also the B2620 had more power to spin all four tires when driving the bucket into a pile of...

How do I increase the lift capacity on my B2601? It seems like the loader loses lifting power the higher it goes. Checked the hydraulic fluid and its full. Any ideas?