Search results

Two part question. I have an ‘84 B7200HST. First part- I have around 450 of ballast on the 3 point. When I set the 3 point about a foot off the ground, the loader will start to lift when I push the loader control valve to the float position. Obviously the loader and 3 point are operated...

I’m going to start taking care of my neighbor’s 250 ft(+or-) reclaim driveway . Is a 5 ft landscape rake too much for my 17hp B7200HST to handle? I wanted to be able to make angle adjustments to control the material and was concerned that a 4ft would be too small. The rear width of the...

I own a 1983 B7200HST. I have started looking into why my flashers do not work. I removed the steering wheel and dashboard. I have no power to the hazard switch. I ran a wire from the battery to where the red wire connects to the switch. This gives me power to the lights but they do not...

The water pump on my 86 B7200 has failed. Belt screaming, fan not turning except for a fraction of a second when the motor is turned off. Alternator is quiet and spins freely. This is what I found on Ebay-...

Today I started building my counterweight for my B7200HST. After finding a 15 gal barrel, I made a trip to TSC and bought a 20” cat 1 drawbar, a couple of L brackets, and some 3/8” bolts and nuts. 5 bags of concrete were bought at Lowes. Other parts and materials were old supplies I had on...

With severe dry rot and rims suffering from the effects of calcium ballast, it was time for rear tire and rim replacements on my new to me B7200HST. Got an estimate of $1000 from my local Kubota dealer. Rims were $107 each, 6 newer style acorn nuts were $25. Tires were $367 each.:eek: The...

I***8217;m in the middle of servicing the transmission on my B7200HST. Drained oil and replaced the filter. I put in one gallon of oil and suddenly remembered I hadn***8217;t cleaned the suction filter.:mad: Do I remove this large bolt at the end of the tube to access it and is there anything...

The Husco loader valve on my B7200HST failed. I replaced it with a Prince 8 gpm loader valve. Replacement went smoothly. Am trying to get the air bled out of the lines. Any tricks? Right now the bucket will lift and roll just a little bit when I move them. I worked them for about a minute...

I’m about to purchase a mid 80’s B7200HST. Woods 1006 loader. Last winter the loader control valve failed. The steel piston coming out of the valve, which controls the bucket roll, broke where the control arm attaches. It currently has a pair of vice grips on the stub, which functions. The...