Search results

Hi, I'm looking for a B6000 cylinder head. ZL600 two cylinder diesel engine Part# 15231-03116 now 15231-03200 send me a note if you have one Todd

Hi All, I have an old B6000. She has been a great tractor but she seems very sick. It has been hard to start for quite a while. Lots of blue smoke, only firing on one cylinder after long preheat (even in summer). I went out to start the other day and she coughed up a lot of liquid from the...

Hi, I'm looking for a new rear rim for my L245DT. Rim is stamped TOPY 12-79 W9 x 24 8.2. It has 11.2 / 10 X 24 ag tires. Web search yields part# 32470-27650 cost about $370. I also found W9 X 24 rim at Wold Rim & Wheel cost about $100. The only difference seems to be Kubota has an "S"...

Hi All, My old B6000 seems to have a major problem. It has always been hard to start and blows a lot of blue smoke until warmed up. I was running it yesterday. Seemed normal for about 1/2 hour. Then it started to "knock" very loudly. Oil pressure light began to flicker On/Off (normally...

I'm looking for any comments about a 3ph Dr Chipper. I saw one on craigs list for $750 and was currious if they are worth the money. I have 25 acres of forest with lots of brush to clean up. I realize that it won't be as fast as a big chipper, but will it cleanup brush faster than piling and...

The oil pressure light on my B6000 keeps turning on. Tractor starts OK and runs fine. After 10 or 15 minutes the light comes on. I have changed the oil and filter. The oil was nasty, very black, thick and gooey. Ran the tractor a few times with no light. I was out plowing snow today and...

I'm thinking of buying a bolt on tooth bar for my FEL. Has anyone used one of these, and do they hold up? Or, am I better off welding teeth on the bucket and using the back edge to smooth things off.

Is there a trick to removing the fuel injectors? I removed the mounting bolts, and if I tap the injector with a hammer it will move a little. But I can not get them out. Any help appreciated Todd

I just split my B6000 to replace the clutch. I noticed something odd. There is a u joint where the front wheel drive shaft meets the front axle. The axle and joint have a cover and tube over them for protection. The cover has what look like oil fill and drain plugs, but there is no oil in...

The rear brakes on my B6000 are worn out. I have searched the net for brake pads but they are quite expensive ($180 usd per pair). I haven't pulled it apart yet to see what they look like. I assume it is an asbestos pad glue and/or riveted to the shoe. Is there a way to replace the pads on...

The clutch will not disengage completely. I have adjusted the linkage to maximum lenght, but there is still way to much freeplay in the pedal. I do not have any strange noises as mentioned in your video. When in gear, there is no slippage that I have noticed. I had the clutch replaced years...