Search results

Hi folks, I have a g4200 that I'm having issues with the key switch housing rotating in the hole in the dash when you twist the key to start it. There doesn't appear to be anything to keep it from rotating except tightening the nut on the outside of the dash. I've seen other switches that...

I have a G4200 that I swapped a D662 into and I have very similar coolant temps - in fact mine will get up to ~220°F when mowing fast on a hot day. I used the same radiator from the Z430 engine for the D662. I have a 13 psi radiator cap (from an older Honda Civic - at least that's what the...

I put a coolant gauge on a D662 engine that I swapped into a G4200. The D662 was out of a Toro greensmaster, I think. Anyway, the coolant port was 3/8" pipe thread - probably BSPT since it is a metric engine, but NPT works well enough in this low pressure application. The engine that I...

Or grind a point (or truncated cone) on your grade 8 bolt. Kevin

I put a d662 into a kubota G4200. The engine that I have had the same exhaust manifold that you listed first when I got it, with the outlet pointing straight up. I have the old one that I can measure if you need some dims. I ended up using a manifold off of a d600, used in the G5200H mower...

Re: Diesel Motorcycle If you still haven't found a stub shaft, Hayes mfg has them for SAE flywheels, which is what the super mini kubota uses. I believe it's a SAE 6 1/2" flywheel. Looks like they offer them in 1.5" and 1.75" dia shafts. Their website also says that they make custom pieces...

I just rebuilt the spindles and gearbox on a RC44g, which looks the same as your deck except for a few different mounting brackets and the gear box is turned 180 degrees. It's wasn't bad at all - I probably have less than $100 in the rebuild. I bought the seals from Kubota, which was ~$60...

Hey Folks, I just purchased a category 0 3pt hitch for my G4200 from a very nice lady in Kentucky. The hitch lift is hydraulically powered, and from what the seller told me, it can be connected to the hydrostatic tranny on my G4200 to drive the hydraulics. The hitch mounting definitely is...