Search results

Sometime there were hard time to start my BX2200 2004 tractor. I replaced battery today and there was sound of warming up initially, and then completely silent after turning the key to ignition. I checked each of the fuse and they seems all good. What may be the problem here? Many thanks.

Hi dismith, thanks for the info. the front load on BX2200 is LA211. I look up online and did not find clear image showing the control box. But it seems that on BX2230 the control box is more accessible. On BX2200 there is a tiny gap between the screw and the wall. It seems no easy way to remove...

One of the hydraulic hose is leaking on my BX2200. I just received a hose brought online. But the new hose comes with a female connector on one side and the current one is male as shown below: Here is the female connector on new hose: Is there a male to male fitting I can use to make the...

Problem solved. It was false connection on + of the battery. The connector was placed up side down which caused weak/false connection. Thanks for everyone!

Im pretty sure there is problem with circuit connection. I left key on on-position and the light is on and clicks for a few second. Now it is dead again after I turned the key. Attached is the fuse box I checked and they are all fine. Is there other fuse I missed?

I don't think there is light. but I will check again. Fuse was the first thing I looked and they seemed all right. It is hard to jack it up. I am wondering if tilt may cause problem. Thank you for the suggestion.

I turned off my BX2200 when its front wheel stuck in a pit. But a few minutes late the BX2200 won't even click when I turned the key. I guess it must be something with the safety switch. What I did was to leave the speed control at Neutral (back and forth quite a few times) and the PTO off (on...

I replaced all the 4 fuses on manual and it can start and keep running now. I may short the fuel line (under seat) by accident and burned the fuse for solenoid.

I have a BX2200 with about 1200 hours has had some problem today. I had to jump start this morning. After running about 1 hour, I stopped the engine and it wouldn't start again. I just put on a new battery and it started and ran as long as I hold on the key at start position. The engine shut off...

My BX2200 won't start. I can hear the clicking sound but nothing happens when the key is turned to start. I measure the battery and it is about 12.5V. When clicking, the voltage drops to about 10V. But it is 2-3V when turning to start. Is the battery should be that low (2-3V) when start? Please...