Search results

I had an old hand fork lift that I modified to serve as a storage stand for my hydraulic auger.

I'm adding a second set of front hydraulics on my L2501 so I needed a new bracket so I built one. The last picture is the new bracket next to the one from Kubota.

My 2017 and 2020 L2501 have rear hydraulics for the backhoe but when you don't have it on the hose for the rear hydraulics are in the way of the rear 3 point lift arm. I made this from an old tool box holder to keep the hose out of the way. I plan to get some of the protective cover fabric for...

I tried to find a kit to buy, I even went to Kubota but I couldn't find a kit to have a Hydraulic powered skid steer quick attach for my L2501 so I'm building one. It works, still need to lube and make some adjustments.

The front axle pivot vent plug on a Kubota L2501 takes a 9/32 square drive socket. If you own one you need one, unless you are some kind of uncivilized barbarian........:ROFLMAO: So people are saying it's 7mm, while I would agree I haven't been able to find a female 7mm pipe plug socket, I did...

I added a tool box to the Left side fender on my sons L2501, I would have painted it but I ran out of time before I have to take it back to him and get mine back. I just used an ammo box and these isolators -

Solution - OrangeMAn suggested it might be behind the loader frame and the block - I pulled the lower bolts on the loader mount and antifreeze trapped in the blind pocket behind the frame came out! So I was doing some maintenance on my sons 2017 L2501 and I noticed it has a coolant leak that...

If you are trying to remove the hood on a L2501 (2017) this image will help see how the hinge is made and how you have to slide the hood forward after you remove the bolt (one on each side). The image of the slots on the hood the rear of the hood is on the left.

after market fuel/water separator filter I don't like the fuel filter on my L2501 so I have been looking for a replacement and I think I found one that will be a lot better then the factory one and I can add a fuel shut off that they should have put on from the factory. Here is what I...

I had used a hand fork lift to build a set of Pallet for my L2501. I posted photos of it and the the suggestion was made that I should rebuild it so I could see though it......so I did.

Since this is the first Diesel of my own I'm always looking for things to help prevent problems that I hear about. Cummins has partnered with Power Source for fuel additives so I have started looking at there products for fuel storage. I think this is something I'm going to try....anyone have...

I've been working on my loader attachment.....it's getting close, its usable but needs a few more things before it goes to powder coat.

It seems like every time see a finish mower post it's about failed spindles but I never realized that it is a serious design flaw in many of the spindles. If you search for the spindles online they are everywhere and cheap (27.00 to 99.00) so I started looking into the design of the 1500.00 to...

I got a good deal on a 5 foot bush hog. I paid 250.00 for it with the part to repair it. Here is the photo of the repaired part, it was easy to replace the splines with a grinder and a welder. I also picked up a finish cutter.....not such a good deal.

I bought a used post hole digger, being naïve I took his work that it was in great shape, lasted 20 min. Here is my repair....I don't think it's going to break off again.

The Back Hoe on my L2501 tractor has a quick disconnect mounting system but what do you do with it once it's off the tractor? Well here is my solution....a roll around carriage.