Search results

here

The complete cylinder is more than $200.00 plus shipping. I can't remember when, but I recall some writeup where earlier model cylinders had a manufacturing defect of scratches or scoring in the cylinder causing premature wear of the seals. Sorry I couldn't find the article it was a long time...

Messicks https://www.messicks.com/part/k2511-16600/kit-seal $48.39

Well aware electrical conn are course threads, since we are guessing as to the thread size I can only suggest something like EBAY or hardware & get a tap of the size you need & thread something to fit (washers, chunk of metal drilled & tapped). searched thru some old boat anchor electronics...

Maybe a threaded ring from an electrical conduit or romex connector?

As was said in previous post, spline is keyed, will only fit one way.

My BX24 runs a little on the hot side when mowing in hot weather, not in the red but close. Just be sure that nothing is clogging the radiator, etc.

OK i found a doc for you, the original instructions for step stay kit. The part you are looking for is 1/4in flat steel plate 1-1/2in wide & 5-1/2in long. Two holes & a piece of steel sticking out about 3/4 from one end, doesn't do much just sits on a ledge. Doubt if it's needed. Photos...

That is the most ridiculous thing ever. It is nothing more than a plate that holds parts 030 & 040 to the frame. Understand at my age it's rather difficult for me to crawl under the tractor to get dimensions. However my son is coming over this weekend & I'll see what we can find. But...

I'll try to get pics, but the fender bottom bolts to the edge of the floor board hole & the bracket bolts to a different hole about 4in in front of the fender edge hole.

OK checked mine & you are using the wrong mounting hole for the bracket. The one you should be using is in the floor board about 4 in ahead of the fender mounting hole you are showing. Fender mounts alone. Attached is a clearer PDF drawing showing bolt 050 in the floor pan in front of the...

I will check mine in the morning, something doesn't look right. Step stay kit: BX2350/1850 part number K2581-9554-0 BX24 Part number K2592-9554-0

This may help.

I have been using a cyclone rake for sometime now & I also had some difficulty lifting the bag when full. What I did was fasten a wheel barrow handle to the left underside of the frame with HD hose clamps (or u-bolts). You can get these from Lowes or most big box stores. This gave me extra...

You could try EA, provided you already have a valve & joystick installed. https://www.everythingattachments.com/Kubota-BX-Series-Tractor-Loader-p/ans-b2405-ldr.htm

One possibility that has come up in the past for the BX's as well as other brands is a mod for the starter relay. Various places to get a kit or make your own . Amazon https://www.orangetractortalks.com/forums/threads/bx2200-a-couple-issues.46925/

Anything can be made to fit, but is it worth it, most likely not. But you will find that the mounts on the 23BX mower are wider apart & have a completely different mounting point than the 22BX mower. The best way to explain is to reference parts diagrams for each mower & it will be much clearer.

You could try EA , maybe this is what you want. https://www.everythingattachments.com/Kubota-BX-Series-Tractor-Loader-p/ans-b2405-ldr.htm