Search results

To solve that problem loaders have a regenerative valve on the dump circuit - apparently your loader is not equipped with that feature.

Wow... Kubota will now have to buy it back from you and thoroughly go thru it to find out what's wrong with it! :eek:

Rexr, Did the dealer even bother to check the steering circuit’s pressure? If so, what was it.

I have a M760HDC18. I think I mentioned this to you in a PM that I tested a MD-071 Cab like yours (wide radial tires in front) and it didn't have any of the troubles you mentioned in this thread. I tested the steering and with just the loader and two men standing in the bucket (I lifted them...

Rexr, Now that the hydraulic system pressure was set to Kubota’s specification, how is the tractor reacting?

Rexr, Your tractor has a separate pump for the steering. Make sure its pressure meets specification too! By the way, now that you have the tinted windows how would you rate its effectiveness in keeping the cab cooler? Thanks...

Nice idea but it's also a good way to bow the bucket!

flogler, I like an analog clock so I bought a battery powered wristwatch from Wall-mart for $15.88, removed the wristband and ground off the little "ears" that hold it. I used velcro to attach the watch to the side pillar of the tractor's cab (cloth side to watch-sticky side to the cab's...

For what it's worth... The specs on the M7060 power steering cylinder is 1750 psi at engine idle. You can test this by removing one of the hoses and inserting a gauge. There may also be air in the line which can be removed by turning the wheels from lock to lock position. If the psi is low...

Please let us know the results. Thanks, Mike

I have a M7060HDC12 which is basically the same tractor as yours without the wider cab. Today I stabbed an approximately 1,800 lb round bale of hay and lifted it as high as the loader would allow. The front wheels turned from "lock to lock" without any hesitation at every position, The engine...

Just curious... Does your tractor have a forward reverse shuttle? Just checking if you have a L275 instead of a L225.

...or cut the steel at the bend; clamp to a straight edge and reweld.

Just curious, is the Tractor''s hydraulic oil level okay?

Do the 3 point hitch hydraulics function normally?

Your tractor is equipped with "bi-speed turning". This feature can be used whenever the steering angle of the front wheel exceeds approximately 25 degrees, the front wheels automatically start turning nearly twice as fast. The result is the tractor can make tight turns smoothly.

bernhardine, Thanks!

I have a m7060 that keeps blowing a fuse labled "meter' backup. What does this protect?

Consult your Tractor''s user manual for the recommended equipment size.

Kubota states in their user manual the following...