Search results

  1. T

    New BX25D, DIY mods

    Thanks for checking, that's helpful.
  2. T

    New BX25D, DIY mods

    Yes it did. I'm all set with those connections to the relay that was also included, but I'm a bit stumped on the best spot to splice in the purple wire that sends the signal to the relay that the ignition is on/off. I know that sounds dumb since it's obvious where the ignition is, but there...
  3. T

    New BX25D, DIY mods

    I got that far, but I'm a bit lost with the rat's nest of wires underneath there. I was hoping someone could direct me to the right wire to splice into.
  4. T

    New BX25D, DIY mods

    Thanks, I really appreciate it. I'm just having trouble figuring out the best spot to tap into the ignition signal wire.
  5. T

    BX25D-Curtis Cab Install (All Steel)

    I just installed mine on my new BX 2370 last week, so I can't really comment on the performance yet. I have the glass rear panel and hard doors and I'm really satisfied with the quality. I got the heater too, but I haven't finished the install yet.
  6. T

    BX25D-Curtis Cab Install (All Steel)

    I had trouble finding the console too. I got it off of eBay but it was from an individual seller so I doubt he had multiple units.
  7. T

    New BX25D, DIY mods

    When you wired the switch, I know that one of the purple wires goes to the relay but where do the other purple and black go to?
  8. T

    New BX25D, DIY mods

    That's a great idea. Did you use a special kind of switch?
  9. T

    New BX25D, DIY mods

    Thanks for the reply. My console came with a relay so that it could be hooked up to go on and off with the key. I just wasn't sure where the best place was to connect the wire that's supposed to go the the key control. I assume from your comment that yours doesn't have a separate relay?
  10. T

    BX25D- Heater installation for a cab

    Thanks, that's helpful. I wasn't sure if it's okay to do that since its a pressurized system.
  11. T

    New BX25D, DIY mods

    t33jetman, I got the same overhead console you have for my new bx2370-1. I'm learning as I go with the install, but I was wondering about the connections near the battery. Do you have any pics you can share to give me some insight? It looks like there might already be a harness there to...
  12. T

    BX25D- Heater installation for a cab

    t33jetman, I just installed the curtis heater in my new bx2370-1, and I have a question. The instructions say to bleed the air out of the coolant system, how exactly do I do that?
  13. T

    BX25D-Curtis Cab Install (All Steel)

    Thanks, I'll check it out
  14. T

    BX25D-Curtis Cab Install (All Steel)

    Hi, this is my first post as I just bought my first tractor! I'm expecting my BX2370-1 to be delivered this week! I purchased the Curtis cab and was also able to find the same radio console that you have online. I was hoping that you might be able to post some additional pictures of how you...