Search results

Is there a rack that I can drive my rtv520 on to elevate it for servicing Thanks

Do I have to bleed the system after changing the water separator filter and spin on fuel filter. I would usually fill the filters up and replace. Thanks for the advice

I have a L3901 and I do notice when going into a pile of dirt I have to back out a bit to curl dirt into my bucket. Don't seem like a lot of power trying to fill my bucket. Thanks

Kubota says they don't make a hydraulic top link for the L3901 and have been (supposedly) working to figure how to install one. I'm Not mechanically inclined so it’s tough ror me. Is this a tough job to do and I already have the third valve for my grapple?

I already have a third function valve for my grapple, I want to add a hydraulic top link, can I come off my third function valve for a remote in the rear for the HYD top link ? if someone could help me figure out the best route I would appreciate it. I own a L3901 that is around 8 years old

A quick question, I have a L3901 HST with 650 hours, I notice lately that the foot pedal for forward and reverse is slow to come back when pressed forward. When I release the pedal it might no stop and creep forward. I didn't notice any grease points in that area. Any advice would be...

Probably should know this but any way, the lift lever goes from 1-8, it only starts lifting at #5. is there a reason for this, thanks for your help

I have a L3901, has anyone messed with he quick attachment rig, where you can just backup and hookup easier to different equipment. Thanks

I bought a new 5’ kingkutter tiller and when I went to check the tine gear box it only has grease in it. The manual said the gear boxes where shipped full. should I add gear oil to the tine gear box that has the grease in it. Thanks in advance for help.

My battery was dead this morning, has been showing signs and is 6 years old, I bought a new battery and installed, after starting I get a flashing code P0606, is this a serious issue. Thanks for your help. My Kubota model is L3901

Just wondering if a 6' tiller behind my L3901 is too much, Would I be better off with a 5 ' tiller. Also I believe a 5' tiller should stay within my back tire width Hopefully. Any feedback and suggestions would be great, I want to purchase one in the next few days. Thanks everyone

I have to remove the front bonnet on a L3901, I believe a rat got in there and chewed my fuel gauge wire. I have to disconnect the DPF and combo switch. Once I remove the steering wheel, the throttle grip,the main switch,can the bonnet be moved enough to reach behind and disconnect the switches...

Hi, the other day I started my L3901 up and the fuel gauge showed empty. I thought maybe someone had emptied my tank. Nope I filled the tank and it still says empty. Not sure if its the gauge or the sending unit in the tank. The fuses are all good. When i start the tractor, the gauge goes to the...

Hello, I am receiving a error flashing after the hours show reading P0336. I was told by the dealer not to worry if the tractor is running. I still worry because I have only 20 hrs on this new unit. Has anyone had this same error or heard anything about it. Thanks