Search results

The slack is in the cylinder not the pins.( Trust me it gets greased before every use.) Say the loader and the bucket are down all the way and the bucket is tilted up so that just the cutting edge of the bucket isn't touching the ground by a few inches. I can stand on the bucket and the rod...

I have a L3200 with 290 hrs. Recently the bucket has trouble raising when digging dirt. Also curling is weak. Raising the engine RPM seems to help some but not much. Tractor had plenty of power when it was new. Loader has never been removed nor has the hydraulic lines. Fluid is full no leaks. I...

Would anybody happen to know the part number for the tachometer cable on a kubota l3200 4x4 DT2012 model.

Not sure what happen when I put it back together but after adjusting the tension on the control valve it is back to where it was before. Thanks for the help and everyone's input.

Does anyone know of link that has a digram of the LA524 FEL. I've search online and have failed to find anything.

This is the bracket I welded. I never unhooked any of the those lines except for the bolt that holds the lever in place.

This is the bottom of the bracket that broke. It just had 2 small tack welds on it.

Some more sorry couldn't get but one at a time to load.

Here are some pictures.

Thanks for that info and i appreciate everyones thoughts. However I am aware of the float control and it's purpose. The float control was working fine before I removed the bracket. After I reinstalled the mounting bracket that the hydraulic control valve sits on. The float position is not the...

I'm calling it reverse but now whenever I pick the tires up off the ground and you push the lever to much it slams the tractor back down this never happen before?

The mounting bracket for my kubota la524 loader broke the other day. After welding the bracket up. I reinstalled it on the tractor. I did not remove any lines from the pump. Now my float control is reversed. Anyone have this problem. Again I did not remove any lines what's so ever. Only the...

I have a l3200 when the key is turned on sometimes the solenoid will engage and then disengage not allowing the tractor to start. It will turn over just not start if I mess with the ignition it will engage allowing it to start. Anyone had this trouble?

I have a L3200 and the 3 point hitch will not lift my disk off the ground. I have adjusted the top link to the bottom hole but still not enough lift. I heard that the feedback rod could be adjusted but not sure where it is located. Can anyone help me out with this.