Search results

  1. M

    rtvx900

    I am getting almost no charge pressure from the hst. it is a new hst with all new pump, filters and regulator valve with new fluid. Any ideas would be greatly appreciated.
  2. M

    Kx040-2

    Any way to remove the terminals from the boost sensor plug...no continuity between computer and sensor plug...bad crimp at wire number 2...new harness is $2300!
  3. M

    svl75-2

    does anyone know if you have to pull the engine on a svl75-2 to time the engine?
  4. M

    Svl75

    Have a svl75 with fuel in the oil... had the injectors tested and are ok...trying to pull just the injector pump but will not come out...any ideas as to what is holding it in?
  5. M

    blowing seals

    I have a BX25dbl tractor with a BT602 backhoe...the backhoe control valve has a pressure relief valve for the swing function of the backhoe and after 30 minutes of use it blows the Teflon seal at the end...pressures are 1700 psi...slightly below specs for operating pressure...50 psi on the...
  6. M

    jerking 3 pt hitch

    Thanks coack...not alot of help but alot of info.
  7. M

    jerking 3 pt hitch

    I have an L 2800 that when you lift the three pt hitch up slowly it jerks the whole tractor. Pull fast and it goes up normally. Pressures are normal @ 2200 psi I think its in the control valve but need some advice.
  8. M

    error code

    does anyone know what a e9310 code is on an svl90-2?
  9. M

    seat belts mandatory

    Thanks Bulldog!
  10. M

    seat belts mandatory

    I have an rtv1100 that wants to throw you through the windshield when you let off the accelerator. Is there an adjustment for this?
  11. M

    kx040-4

    error message on screen to replace the DPF filter. Code P3008, P3007,P3007. Where do I go from here? 758 hours on it.
  12. M

    code 86

    Does anyone know what this referring to?
  13. M

    Zd221

    Is there a neutral lever on a zd221...mower will not go forward or reverse.
  14. M

    Zd221

    PTO is slow to engage... approximately 5-8 seconds. Any ideas as to what is causing this?
  15. M

    error code on a svl90

    E9120 code. what does this reference to on a svl90.
  16. M

    rtv900

    how to remove rear axle and shafts from unit?
  17. M

    kx71-3

    when operating the turret it has a slight grinding noise and vibration when you first start turning. nothing loose and well greased. any ideas would be appreciated.
  18. M

    kx71-3

    kx71-3 has a slight grinding noise when operating the turret only does this when you first start turning. nothing loose and well greased. any ideas would be appreciated.
  19. M

    code identification

    ]does any one know what an e9000 code is?
  20. M

    code identification

    does any one know what an e9000 is?
Top Bottom