Search results

Has anyone installed a oil cooler on their hydros. I have a b3200 & after using tractor hard for a while I noticed a slight drop in hyd. tractor seems sluggish & I can smell hyd. fluid & it is hot , wanted to see if anyone has this same issue

Hi, everyone , I am in need of a right headlight lens for my b3200, push mower threw a rock right into it & it shattered ,

that is correct, the machine shop will measure the crank, and regrind it as little as possible, so you can use the smallest oversized bearing possible

did you check air intake system air filter or colapsed intake hose, black smoke is over fueling, I have seen this before, if tractor has set for a couple days, the critters move in, mice & chipmunks love to build in the air intake system, remember the basics fuel, air & compression, it takes all...

the bluing is from the heat treatment process, the journal has a lot of metal transferance, but , a machine shop should be able to regring it with no problem , I have done this many times, just have to get the bearing measurement for the machine shop, & when you get it back use plastiguage to...

the only way that the camber can change is if the bearings are bad at hte knuckle if you are certian its getting worse pull it apart

your connection must be good, glow plugs pull high amps, any loose or weak connection will overheat, over time open connectors let the terminals get corroded, before replacing glow plugs, I would make solid connecions , remove the connector & connect wires solid, might save lots of time & money...

I've been a diesel mechanic for 27 years , & have rebuilt meny differnt engines , full floatng pins will push in by hand, and will have retainers to hold them in place interferance fit pistons , must never be honed out or have the pin pressed in it will damage the piston & you will pull it back...

where is fitting for pressure guage & what did you use to shim relief valve

just took del. of a new b3200 & wasn't impressed with the fel seems like lack of bucket force , had a smaller green machine that would dig twice what this one will dig, anyone have simmiler problem or know how to increase the digging force