Search results

Turned out that it was the High/low range safety switch, I bypassed it for trouble shooting and it started. Kent :)

Thanks for the advice. I'll be working out of town the next few days and I'll check it out when I get back and let you know the results. Thanks again, Kent

Thanks for the replies. I did check the PTO, Gear Shifter and the high low range shifter and none of them helped. Kent

I used my 1999 M4700 a couple of times today and then parked it. I went to use it again and nothing happens when you turn the key. I checked the 50A fuse and it's ok. I had a spare key switch and changed it out, still nothing. Battery is good. Maybe a safety switch, a:confused:ny suggestions? AKD

Vic, Feedback linkage replaced, lift working fine now. Thanks for your help. Kent

I bought one for ten dollars on ebay. It was emailed in a couple of hours. the seller is low_cost_4_u. Just search ebay for Kubota Manual and his adds should come up. Kent

You might be able to find one here, www.wkytp.com I made a mistake on the first address, this one is right

Sorry it took so long to get back, been working a lot of overtime. Vic, I found the feedback linkage broke on the draft control. I'll get it replaced as soon as I get one. Thanks for all your help. Kent

Thanks Vic, I'll take a look at the linkage this weekend. Eserv, It doesn't make any difference where the draft lever is. The lift will not move until the lift lever is all the way to the top of the range. Thanks for the advice. Kent

Fluid level seems ok. It's about 1/16" below the full line. Kent

New user, first post. This is a great forum. I have a just bought a 1999 M4700. The 3 point lift lever has to be raised all the way before the lift will raise. You can lower to the height where you want to be, then raise just a little to hold there. This makes it hard to do any dirt work. Any...