Search results

I have an MX 5200 HST. Under normal operation, when I take my foot off the HST pedal, the tractor stays put in neutral. Lately, however, the tractor will creep forward. I have lubricated all of the HST linkages, hoping that would do the trick, but the tractor still drifts forward. Any...

I don't usually do this sort of thing but I want to share a terrible experience that I have had with this manufacturer. I purchased this round bale grabber back in August...

I have an MX5200 HST that is 3.5 years old with about 900 hours on it. The initial problem I had with this tractor was back in September when I lost power to the PTO (just as I started to bale hay). I checked the PTO seat switch, PTO solenoid, and various other things and they were all good...

My tractor loses power almost to the point of stalling if I go above creep speed. Additionally, when I engage the PTO, it stalls the tractor. I thought they were two separate problems and I ended up pulling my PTO clutch pump assembly, testing the solenoid, and blowing air through the port...

I have a MX5200 HST. When I depress the shuttle beyond a certain point (say 1.5 mph), I lose all power just short of stalling out. I can move very slowly, but beyond that the whole tractor bogs down. I checked the water separator (all good) as well as the screen in the separator (clean). I...

I went out to bale hay last week and the PTO quit with an E-95 error on the dash (which is loss of PTO function). I checked the PTO switch and seat safety switch - both were fine. With some effort, I located the PTO solenoid, unhitched the wiring harness, and determined that I have 12+ volts...